The Mega Arm Sprint and Mega Arm Sprint Tower are DC-powered, high-speed additions to the LiftMaster® family of gate operators. Designed with a 24V DC (1/2 HP equivalent) motor, these models provide exceptional speed, making them ideal for parking applications. Constructed with an aluminum alloy chassis, they´re corrosion resistant and light enough for one person to carry and install. The heavy-duty motor supports 10,000 cycles per day with an operator speed of .9 seconds to open or close.No power? No problem!Built-in battery backup provides seamless operation of the gate operator and all DC control and sensing devices in the event of a power loss.

 

 

Mega Sprint STANDARD FEATURES:

 

Radio Receiver Built-in

Aluminum Alloy Chassis

Built-in Battery Backup

Soft Start/Stop

DC Operator System

Right or Left-Handed Operation

Breakaway Arm

Control Inputs

Inherent Obstruction Sensing

LED Indicators

Dual Gate Operation

Dynamic Braking

Magnetic Sensors

Timer to Close

 

 

Mega Sprint SPECIFICATIONS: 

 

-Fast access - very quick 1 second open/close time.

-Built in battery backup - inherent 24 VDC backup power with regulated 24VDC for accessories.

-High torque 24 volt Permanent Magnet DC motor.

-Full service controller with eight inputs and LED indicators for loops, card reader, radio, etc…

-Continuous duty operation toll rated at 10,000 cycles per day for all applications (even during power failures). -Reversible arm direction for right or left handed operation.

-Instant Reverse Device (IRD) monitor senses obstructions going open and close.

-Automatic open of gate arm when power is lost if desired (With 15 sec. delay selection).

-Raise gate input memory will memorize multiple vehicles-ideal for barcode scanners & AVI.

-Ability to have arm STOP in close travel if tailgating is sensed at close loop.

-Break away mounting design for the 4" x 9 Ft. soft padded aluminum safety arm (yellow).

-All rust proof aluminum construction with powder coat baked on enamel.

-Molded Polyethylene UV stabilized cover never needs wax or paint (white or colors).

-Direct drive gear reducer eliminates many parts that might otherwise fail.

-Microprocessor (RISC) based electronics with watch dog reset timer.

-State of the art MOSFET motor drive technology, NO contactors or relays.

-Dynamic motor braking to preserve arm positioning.

-Soft start and stop in open and close travel motions.

-No limit switches to fail-uses magnetic (Hall Effect) sensors to monitor arm position.

-Maximum Run Timer for motor (MRT) with anti-tamper protection in closing direction.

-Each unit configurable as master or slave operator.

-Safe 24 VDC low voltage motor and control wiring.

-Open architecture PCB with space for OVERDRIVE CPU for future expanded options.

-LED diagnostic center for easy on-site trouble shooting.

-Closing timer adjustable from 1-33 seconds with on / off selection.

-Transorb diodes on all inputs for protection against transient voltage spikes.

-Capable of being powered by 120 VAC, 220 VAC or Solar power, standard.

-U.L. LISTED (U.S.), C-U.L. LISTED (CANADA)

-10 year perforation warranty on cover and chassis with 2 year on electronics and mechanism.

-Interlock with memory when connected to a slide/swing gate operator, barrier will wait to raise until that unit reaches its full open position. Barrier will not raise if slide/swing gate is tampered with.

-Tail gate alarm-K1 relay can be programmed to fire when a tail gater is sensed on the close loop.